Progress In Electromagnetics Research
ISSN: 1070-4698, E-ISSN: 1559-8985
Home | Search | Notification | Authors | Submission | PIERS Home | EM Academy
Home > Vol. 99 > pp. 405-426


By S. N. Starostenko and K. N. Rozanov

Full Article PDF (412 KB)

The effect of magnetic bias on dielectric spectra of composite sheets filled with Fe or Co-based microwires is studied experimentally and via simulation. The permittivity is measured using a free-space technique within the frequency band from 6 to 12 GHz. The bias is applied either parallel or perpendicular to the microwave electric field; the bias strength varies from 0 to 2.5 kOe. The composites with Fe-based wires reveal a single region of bias dependent permittivity under bias about 800-1000 Oe. The composites with Co-based wires reveal two such regions: the high-field region is close to that of composites with Fe wires, and the low-field region corresponds to the coercive field of Co wires (2-3 Oe). The high-field effect is related to the dependence of ferromagnetic resonance (FMR) parameters on bias; the low-field effect is related to the rearrangement of the domain structure of Co-based wires. The interference of magnetoimpedance and dipole resonance is analyzed, revealing the effects off wire length, diameter, parameters of magnetic resonance and composite structure. The results are considered in view of application to the problem of controlled microwave attenuation. Simulation shows that the narrower is the FMR spectrum and the higher is the admissible loss of a sheet in a transparent state, the wider is the dynamic range of attenuation control. The attenuation range of a lattice of continuous wires is smaller than that of a screen with identical wire sections, where the magnetoimpedance effect is amplified resonantly. At 15 GHz frequency the strength of the bias switching opaque sheet with Fe-based wires to the transparent state is about 2000 Oe. For 3 dB admissible loss, the range of attenuation control about 10 dB is feasible in a composite with aligned wire sections. If the aligned sections are distributed regularly, the loss in a transparent state is about 1 dB lower.

S. N. Starostenko and K. N. Rozanov, "Microwave Screen with Magnetically Controlled Attenuation," Progress In Electromagnetics Research, Vol. 99, 405-426, 2009.

1. Tennant, A. and B. Chambers, "Adaptive radar absorbing structure with PIN diode controlled active frequency selective surface," Smart Mater. Struct., Vol. 13, 122-126, 2004.

2. Smith, F. and R. Gupta, "Principles and demonstration of multi-functional adaptive electromagnetic screen," El. Lett., Vol. 39, No. 13, 967-969, 2003.

3. Schoenlinner, B., A. Abbaspour-Tamijani, L. C. Kempel, and G. M. Rebeiz, "Switchable low-loss RF MEMS Ka-band frequency-selective surface," IEEE Trans. Microw. Theory Techn., Vol. 52, 2474-2481, 2004.

4. Sarkar, D., P. P. Sarkar, S. Das, and S. K. Chowdhury, "An array of stagger-tuned printed dipoles as a broadband frequency selective surface," Microw. Opt. Techn. Lett., Vol. 35, 138-140, 2002.

5. Teo, P., K. A. Jose, Y. B. Gan, and V. K. Varadan, "Beam scanning of array using ferroelectric phase shifters," El. Lett., Vol. 36, No. 19, 1624-1626, 2000.

6. Zhang, R., A. Barnes, K. L. Ford, B. Chambers, and P. V. Wright, "A new microwave smart window based on a poly (3, 4-ethylenedioxythiophene) composite," J. Mat. Chem., Vol. 3, 16-21, 2003.

7. Salahun, E., G. Tanne, and P. Queffelec, "Enhancement of design parameters for tunable ferromagnetic composite-based microwave devices: Application to filtering devices," Digest of 2004 IEEE MTT-S Int. Microwave Symp., Vol. 3, 1911-1914, 2004.

8. Starostenko, S. N., K. N. Rozanov, and A. V. Osipov, "Microwave properties of composites with glass coated amorphous magnetic microwires," JMMM, Vol. 298, 56-64, 2006.

9. Acher, O., P.-M. Jacquart, and C. Bosher, "Magneto-impedance in glass-coated comnsib amorphous microwires," IEEE Trans. on Magn., Vol. 30, No. 6, 4542-4550, 1994.

10. Makhnovskiy, D. P. and L. V. Panina, "Field dependent permittivity of composite materials containing ferromagnetic wires," J. Appl. Phys., Vol. 93, No. 7, 4120-4129, 2003.

11. Antonov, A., A. Granovsky, A. Lagarkov, N. Perov, and N. Usov, "The features of GMI effect in amorphous wires at microwawes," Physica A, Vol. 241, 420-424, 1997.

12. Buznikov, N. A., A. S. Antonov, A. L. Dyachkov, and A. A. Rakhmanov, "Peculiarity of frequency dispersion of nonlinear magnetoimpedance in multilayer films," Journal of Technical Physics, Vol. 74, No. 5, 56-62, 2004 (in Russian).

13. Lagarkov, A. N., S. M. Matitsin, K. N. Rozanov, and A. K. Sarychev, "Dielectric properties of fiber-filled composites," J. Appl. Phys., Vol. 84, No. 7, 3806-3818, 1998.

14. Meyer, E., H.-J. Schmitt, and H. Sewerin, "Dielektrizitatskon-stante und permeabilitat kunstlicher dielectrika bei 3 cm wellenlange," Z. Angew. Physik, Vol. 8, No. 6, 257-263, 1956.

15. Acher, O., M. Ledieu, A.-L. Adenot, and O. Reynet, "Microwave properties of diluted composites made of magnetic wires with giant magneto-impedance effect," IEEE Trans. on Magn., Vol. 39, No. 5, 3085-3090, 2003.

16. Berzhansky, V. N., V. I. Ponomarenko, V. V. Popov, and A. V. Torkunov, "Measuring the impedance of magnetic microwires in a rectangular waveguide," Technical Physics Letters, Vol. 31, No. 11, 959, 2005.

17. Baranov, S. A., "Permeability of an amorphous microwire in the microwave band," Journal of Communications Technology and Electronics, Vol. 48, No. 2, 226-228, 2003.

18. Reynet, O., A.-L. Adenot, S. Deprot, and O. Acher, "Effect of the magnetic properties of the inclusions on the high-frequency dielectric response of diluted composites," Phys. Rev. B, Vol. 66 , 094412, 2002.

19. Vazques, M. and A. Hernando, "A soft magnetic wire for sensor applications," Phys. D, Appl. Phys., Vol. 29, 939-951, 1996.

20. Starostenko, S. N., A. P. Vinogradov, and S. G. Kibetz, "Performance enhancement of a dallenbach absorber due to frequency dispersion of the permittivity," Journal of Communications Technology and Electronics, Vol. 44, No. 7, 761-769, 1999.

21. Starostenko, S. N., K. N. Rozanov, and A. V. Osipov, "Microwave properties of composites with glass coated amorphous magnetic microwires," MISM-2002, Book of Abstracts, 314, 2002.

22. Starostenko, S. N., K. N. Rozanov, and A. V. Osipov, "Microwave properties of composites with chromium dioxide," JMMM, Vol. 300, 70-73, 2006.

23. Brehovskih, L. M., Waves in Layered Media, Academic Press, London, NY, 1960.

24. Lagarkov, A. N., A. K. Sarychev, T. R. Smychkovich, and A. P. Vinogradov, "Effective medium theory for microwave dielectric constant and magnetic permeability of conducting stick composites," Journal of Electromagnetic Waves and Applications, Vol. 6, No. 9, 1159-1176, 1992.

25. Makhnovskiy, D. P. and L. V. Panina, "Field-dependent surface impedance tensor in amorphous wires with two types of magnetic anisotropy: Helical and circumferential," Phys. Rev. B, Vol. 63, 144424, 2001.

26. Usov, N. A., A. S. Antonov, and A. N. Lagarkov, "Theory of giant magneto-impedance effect in amorphous wires with different types of magnetic anisotropy," JMMM, Vol. 185, 159-173, 1998.

27. Melo, L. G. C., P. Ciureanu, and A. Yelon, "Permeability deduced from impedance measurements at microwave frequencies," JMMM, Vol. 249, 337-341, 2002.

28. Dominguez, M., J. M. Garcia-Beneytezb, M. Vazquez, and S. E. Lo, "Microwave response of amorphous microwires: Magnetoimpedance and ferromagnetic resonance," JMMM, Vol. 249, 117-121, 2002.

29. Sandacci, S. I., D. P. Makhnovskiy, and L. V. Panina, "Valve-like behavior of the magnetoimpedance in the GHz range," JMMM, Vol. 272-276, 1855, 2004.

© Copyright 2014 EMW Publishing. All Rights Reserved