PIER
 
Progress In Electromagnetics Research
ISSN: 1070-4698, E-ISSN: 1559-8985
Home | Search | Notification | Authors | Submission | PIERS Home | EM Academy
Home > Vol. 49 > pp. 273-289

NUMERICAL SIMULATION OF MICROWAVE HEATING ON CHEMICAL REACTION IN DILUTE SOLUTION

By K.-M. Huang, Z. Lin, and X. Yang

Full Article PDF (2,629 KB)

Abstract:
Currently, microwaves are widely used in chemical industry to accelerate chemical reactions. Some research results have shown that microwave heating can significantly accelerate the reaction. However, there is a need to develop efficient methods to improve the design of microwave applicator in chemistry. In this paper, a numerical model was presented to study the microwave heating on saponification reaction in test tube, where the reactant was considered as a mixture of dilute solution. The coupled electromagnetic field equations, reaction equation (RE) and heat transport equation (HTE) were solved by using finite difference time domain (FDTD) method. To overcome the difficulty of long time calculation with FDTD, two types of techniques were employed. To verify the methods, the temperature rising in the test tube and transmitted power through the transversal electromagnetic (TEM) cell were measured and compared with the computational results. Good agreement can be seen between the measured and calculated results.

Citation: (See works that cites this article)
K.-M. Huang, Z. Lin, and X. Yang, "Numerical Simulation of Microwave Heating on Chemical Reaction in Dilute Solution," Progress In Electromagnetics Research, Vol. 49, 273-289, 2004.
doi:10.2528/PIER04042803
http://www.jpier.org/PIER/pier.php?paper=0404283

References:
1. Jin, Q., S.Dai, and K.M. Huang, Microwave Chemistry, Sciences Press, Beijing, 1999.

2. Chen, M., J. W. Hellgeth, E. J. Siochi, T. C. Ward, and J. E. Mcgrath, "The microwave processability of semicrystalline polymers," Journal of Microwave Power and Electromagnetic Energy, Vol. 23, No. 17, 160-170, 1984.

3. Bak er-Jarvis, J. and R. Inguva, "Dielectric heating of oilshales by monopoles and modified coaxial applicators," Journal of Microwave Power and Electromagnetic Energy, Vol. 23, 160-170, 1984.

4. Zhang, H. and A.K.Datta, "Coupled electromagnetic and thermal modeling of microwave oven heating of foods," Journal of Microwave Power & Electromagnetic Energy, Vol. 35, No. 2, 71-86, 2000.

5. Harms, P.H., Y.Chen, R.Mittra, and Y.Shimon y, "Numerical modeling of microwave heating systems," Journal of Microwave Power & Electromagnetic Energy, Vol. 31, No. 2, 114-122, 1996.

6. Haala, J.and W.Wiesb eck, "Simulation of microwave, conventional and hybrid ovens using a new thermal modeling technique," Journal of Microwave Power & Electromagnetic Energy, Vol. 35, No. 1, 34-44, 2000.

7. Thomas Jr., J.R.and F.F aucher, "Thermal modeling of microwave heated and fluidized bed catalytic reactors," Journal of Microwave Power & Electromagnetic Energy, Vol. 35, No. 3, 165-175, 2000.

8. Daniels, F., R. A. Alberty, J. W. Williams, C. D. Cornwell, P. Bender, and J. E. Harriman, Experimental Physical Chemistry, McGraw-Hill Inc., New York, 1975.

9. Ma, Y., K. M. Huang, K. Wang, and N. Liu, "Calculation of electric field distribution in TEM cell with EUT," Chinese Journal of Radio Science, Vol. 15, No. 1, 75-79, 2000.

10. Rohsenow, W.M. , et al., Handbook of Heat Transfer Fundamentals, 2 Ed., McGraw-Hill, 1985.

11. Torres, F. and B. Jecko, "Complete FDTD analysis of microwave heating processes in frequency-dependent and temperaturedependent media," IEEE Trans. on Microwave Theory Tech., Vol. 45, 108-116, 1997.
doi:10.1109/22.552039

12. Allen T., Advances in Computational Electrodynamics, Artech House, Inc., 1998.


© Copyright 2014 EMW Publishing. All Rights Reserved