volume | PIER Journals

Abstract

In the general framework of intelligent transportation, the increasing use of information communication technology in full or hybrid electric vehicles requires careful assessment of electromagnetic compatibility, with specific reference to the conducted emissions (CE) generated by the inverter in a broad frequency range (10 kHz-100 MHz). To this aim, this work reports a modelling approach for the prediction of CE in electric powertrains, which is based on circuit representation of each single subsystem, that is, the battery, the inverter, the three-phase synchronous motor, and the power buses composed of shielded cables. The proposed models are able to represent both low-frequency functional aspects and high-frequency parasitic effects of paramount importance for CE analysis, and can be implemented into a Simulation-Programme-with-Integrated-Circuit-Emphasis (SPICE) solver. The proposed modelling approach is exploited to simulate virtual CE measurements according to international standard CISPR 25, and to investigate the impact of setup features, including grounding connections of shields, the propagation of CE in electrically long power buses, the operating point (power, torque, speed) of the motor-drive system.

1. Guo, Y. J., L. F. Wang, and C. L. Liao, "Modeling and analysis of conducted electromagnetic interference in electric vehicle power supply system," Progress In Electromagnetic Research, Vol. 139, 193-209, 2013.
doi:10.2528/PIER13031101

2. Paul, C. R., Introduction to Electromagnetic Compatibility, Wiley & Sons, Inc., New York, 1992.

3. Staunton, R. H., S. C. Nelson, P. J. Otaduy, J. W. McKeever, J. M. Bailey, S. Das, and R. L. Smith, "PM motor parametric design analyses for a hybrid electric vehicle traction drive application," Technical Report ORNL-TM-2004-217, Oak Ridge National Laboratory, 2004.

4. Reuter, M., T. Friedl, S. Tenbohlen, and W. Kohler, "Emulation of conducted emissions of an automotive inverter for filter development in HV networks," Proc. IEEE Int. Symp. on Electromagn. Compat., 236-241, Denver, CO, August 5-9, 2013.

5. Reuter, M., S. Tenbohlen, and W. Kohler, "The influence of network impedance on conducted disturbances within the high-voltage traction harness of electric vehicles," IEEE Trans. Electromagn. Compat., Vol. 56, No. 1, 35-43, February 2014.
doi:10.1109/TEMC.2013.2273564

6. Boglietti, A. and E. Carpaneto, "Induction motor high frequency model," Proc. IEEE Industry Applications Conference, 1551-1558, 1999.

7. Pan, X., R. Ehrhard, and R. Vick, "An extended high frequency model of permanent magnet synchronous motors in hybrid vehicles," Proc. EMC Europe 2011, 690-694, York, UK, September 26-30, 2011.

8. Spadacini, G., F. Grassi, and S. A. Pignari, "SPICE simulation in time-domain of the CISPR 25 test setup for conducted emissions in electric vehicles," Proc. APEMC 2015, 569-572, Taipei, Taiwan, 2015.

9. Guo, Y. J., L. F. Wang, and C. Liao, "Systematic Analysis of conducted electromagnetic interferences for the electric drive system in electric vehicles," Progress In Electromagnetic Research, Vol. 134, 359-378, 2013.
doi:10.2528/PIER12092816

10. Ran, L., S. Gokani, J. Clare, K. J. Bradley, and C. Christopoulos, "Conducted electromagnetic emissions in induction motor drive systems. Part I: Time domain analysis and identification of dominant modes," IEEE Trans. Pow. Elect., Vol. 13, No. 4, 757-767, July 1998.
doi:10.1109/63.704152

11. Revol, B., J. Roudet, J.-L. Schanen, and P. Loizelet, "EMI study of three-phase inverter-fed motor drives," IEEE Trans. on Industry Applications, Vol. 47, No. 1, 665-672, January/February 2011.
doi:10.1109/TIA.2010.2091193

12. Ran, L., S. Gokani, J. Clare, K. J. Bradley, and C. Christopoulos, "Conducted electromagnetic emissions in induction motor drive systems. Part II: Frequency domain models," IEEE Trans. Pow. Elect., Vol. 13, No. 4, 768-776, July 1998.
doi:10.1109/63.704154

13. Beltramelli, A., F. Grassi, G. Spadacini, and S. A. Pignari, "Modeling conducted noise propagation along high-voltage DC power buses for electric vehicle applications," Proc. ICCVE 2014, Int. Conf. on Connected Vehicles and Expo., 1-6, Vienna, Austria, November 3-7, 2014.

14. "Vehicles, boats, and internal combustion engines --- Radio disturbance characteristics --- Limits and methods of measurement for the protection of onboard receivers," CISPR 25, IEC, 2008.

15. Mohan, N., T. M. Undeland, and W. P. Robbins, Power Electronics, Converters, Applications, and Design, 2nd Ed., John Wiley & Sons, Inc., New York, 1995.

16. Paul, C. R., Analysis of Multiconductor Transmission Lines, John Wiley & Sons, Inc., New York, 1994.

17. IXYS Corporation, , 650V XPT Trench IGBTs GenX4, Model IXXN110N65C4H1 Data Sheet, 2013, PSPICE model available: http://www.ixys.com/TechnicalSupport/pspice.aspx.

18. Cadence Design Systems, Inc., , Orcad Capture 16.6 User Guide, 2012.

19. Spadacini, G., F. Grassi, D. Bellan, S. A. Pignari, and F. Marliani, "Prediction of conducted emissions in satellite power buses," International Journal of Aerospace Engineering, 1-10, Article ID 601426, 2015.

20. Spadacini, G., D. Bellan, S. A. Pignari, R. Grossi, and F. Marliani, "Prediction of conducted emissions of DC/DC converters for space applications," Proc. APEMC 2010, 810-813, Beijing, China, April 12-16, 2010.

21. Liou, W.-R., H. M. Villaruza, M.-L. Yeh, and P. Roblin, "A digitally controlled low-EMI SPWM generation method for inverter applications," IEEE Trans. Ind. Inf., Vol. 10, No. 1, 73-83, February 2014.
doi:10.1109/TII.2013.2261078

Dr. Giordano Spadacini

Dr. Flavia Grassi

Prof. Sergio A. Pignari