A new method to improve the gain of circular waveguide array antenna with metamaterial structure is presented. The electromagnetic characteristics of metamaterial and circular waveguide antenna with metamaterial structure are studied by using numerical simulation method, which are also compared with those of the conventional circular waveguide antenna. The simulation and experimental results show that this method is effective and metamaterial structure can realize congregating the radiation energy, so the gain of the antenna increases while the side lobe level decreases.

The design of a compact, single feed, dual frequency dual polarized and electronically reconfigurable microstrip antenna is presented in this paper. A square patch loaded with a hexagonal slot having extended slot arms constitutes the fundamental structure of the antenna. The tuning of the two resonant frequencies is realized by varying the effective electrical length of the slot arms by embedding varactor diodes across the slots. A high tuning range of 34.43% (1.037-1.394 GHz) and 9.27% (1.359-1.485 GHz) is achieved for the two operating frequencies respectively, when the bias voltage is varied from 0 to -30 V. The salient feature of this design is that it uses no matching networks even though the resonant frequencies are tuned in a wide range with good matching below -10 dB. The antenna has an added advantage of size reduction up to 80.11% and 65.69% for the two operating frequencies compared to conventional rectangular patches.

In this paper a programmable beam-switching algorithm for planar phased array antenna is presented. Using micro-controller the planar array can be steered over 49 directions over the complete hemisphere. Each element is connected to delay lines and switching module. The bits at micro-controller output after being amplified by driver circuit are fed to the switching modules which control the insertion of fixed phase tapering. Switching is performed on a unique set of delay lines to steer the beam in particular direction in the horizon. For high frequency application PIN diode is used as switch. In total 12 bits are used to select 49 beam positions with some bit patterns being redundant.

In this communication a comprehensive study of the dielectric properties of human breast milk at microwave frequencies is reported. The samples are collected at weekly intervals following child birth. Measurements are made at the S -band of microwave frequency employing the rectangular cavity perturbation technique. The dielectric constants of the breast milk samples are found to increase as weeks elapse, which is attributed to the reduced fat content and increased lactose concentration. The conductivity of the breast milk samples is similarly found to increase due to the increased dilution.

A general method is proposed to frequency domain analysis of inhomogeneous two-dimensional periodic gratings. Each component of electromagnetic fields is expressed by several spatial harmonic plane waves. Then, two differential equations are obtained for the reflection and transmission matrices, using wave-splitting approach. Solving these equations gives us the co- and cross-polarized reflection and transmission coefficients. The method is studied using some examples.

In the present paper a simple model has been given to simulate the signal propagation through two cross orthogonal microstrip lines in two different layers of the PCB board. First the structure has been analyzed using full wave software like HFSS, then a simple and suitable lumped equivalent circuit is proposed for the cross talk region and its parameters are obtained. Finally the sparameters of this equivalent circuit compared with the results of full wave simulations. The results show good agreement up to some GHz.

The paper discusses the experimental analysis on a cylindrical dielectric resonator antenna (DRA) with a parasitic conducting strip, loaded coplanar with the 50Ω microstripline feed. The antenna offers an impedance bandwidth as high as 17.33% at a centre frequency of 2.77 GH_z, as a result of the enhanced coupling produced by the coplanar strip. The return loss, impedance, polarization and radiation characteristics of the antenna are studied. The radiation patterns are broad and the low cross-polarisation levels confirm that the antenna is linearly polarised over the entire impedance bandwidth.

A waveguide magic tee at W band is analyzed exactly and developed. The analysis approach is a combination of the mode expansion method and finite element method, which is based on the weak form of Helmholtz equation. Mode expansion instead of PML (Perfectly Matched Layers) is used to truncate the computing space of finite element. A magic tee at W band (75∼110 GHz) with the structure, which is easy for manufacture, is developed. Calculated results are presented and compared to those in experiments. Agreement has been observed. A sensitivity analysis is carried out, which shows the influence of the tolerance of manufacture on the performance of the magic tee. And the power carrying capacity of the designed magic tee is also evaluated.

This paper presents a simple broadband proximity- coupled microstrip patch antenna. A circular patch is used as the main radiator, and an H-shaped shot is cut in the ground plane below the feed line. A stepped-width microstrip line is used to feed the patch through proximity coupling. By using a single patch, the prototype antenna achieves an impedance bandwidth of 26%. Low cross-polar levels below -20 dB are observed in both E- and H -planes. The broadband antenna is planar, small size, simple in structure, low in cost, and easy to be fabricated, thus attractive for practical applications.

A method is proposed for analysis of arbitrarily loaded lossy and dispersive nonuniform single or coupled transmission lines. In this method, all the per-unit-length parameters or matrices of the single or coupled lines and also the voltages and currents along the length of them are expanded in Taylor′s series. The solutions of voltages and currents are obtained after finding unknown coefficients of their series. The accuracy of the method is studied using analysis of some special types of single and coupled transmission lines.

In this article, an efficient method for the pattern synthesis of the linear antenna arrays with the prescribed null and multi-lobe Beamforming is presented. Multi-lobe pattern and adaptive nulling of the pattern is achieved by controlling only the phase of each array element. The proposed method is based on the Sequential Quadratic Programming (SQP) algorithm and the linear antenna array synthesis was modelled as a multi-ob jective optimization problem. Multi-ob jective optimization is concerned with the maximization (or minimization) of a vector of ob jectives functions in the directions of desired signal that can be sub ject of a number of constraints (in our case, the constraints can be imposed as the null in the direction of interfering signal). To verify the validity of the technique, several illustrative examples of uniform excited array patterns with the main beam is placed in the direction of the useful signal and null is placed in the direction of potential interferers, and multi-beam patterns are demonstrated.

The Lorentz transformation group of the special theory of relativity is commonly represented in terms of observer′s, or coordinate, time and coordinate relative velocities. The aim of this article is to uncover the representation of the Lorentz transformation group in terms of traveler′s, or proper, time and proper relative velocities. Following a recent demonstration by M. Idemen, according to which the Lorentz transformation group is inherent in Maxwell equations, our proper velocity Lorentz transformation group may pave the way to uncover the proper time Maxwell equation

In this paper, the exact formulas are derived for the timedomain electromagnetic field generated by a delta-function current in a horizontal electric dipole located on the planar boundary between a homogeneous isotropic medium and one-dimensionally anisotropic medium. Similar to the isotropic case, the amplitude of the tangential pulsed electric field along the boundary is 1/ρ², which is characteristic of the surface-wave or lateral pulse. The tangential electric field consists of a delta-function pulse travelling in Region 2 (anisotropic medium), a oppositely directed delta-function travelling in Region 1 (isotropic medium), and a final static electric field due to the charges left on the dipole. It is seen that the pulsed electromagnetic field components consist of the first and second pulsed in the two regions with different velocities.

In this paper, the physical spline finite element method (PSFEM) is applied to the fullwave analysis of inhomogeneous waveguides. Combining (rectangular) edge element and the PSFEM, the cubic spline interpolation is successfully applied to the wave equation. For waveguide problems, the resulting nonlinear eigenvalue problem is solved by a simple iteration method in which the initial estimate is taken as the linear Lagrange interpolation, and then the solutions are improved by a few iterations. The bandwidth of the resultant matrix from the PSFEM is the same as that of linear Lagrange interpolation and is sparse. As a result, sparse matrix solver can be used. Three typical examples are demonstrated and compared with the analytical solutions and with the linear Lagrange interpolation results. It is observed that the present method converges much faster than the Lagrange interpolation method.

This paper presents an experimental Phased Array Antenna System operating at 10 GHz. Geometry of the antenna array is cylindrical. Antenna element excitation phases are adjusted at the intermediate frequency stage. Antenna element excitation amplitudes are taken to be constant. A least squares technique is used for phase computation and radiation pattern synthesis. The obtained radiation patterns provide steerable main lobes and nulls at predefined directions including control of the side lobes at specified levels. Units of the system are presented in detail and their architecture is explained. A phase calibration is used to compensate the system. Measurements of radiation patterns are presented and are compared with calculated patterns.

In this paper, we investigate the thermal noise behavior of the multi-antenna communication systems, when antenna elements are closely spaced. We analyze the mutual coupling effect on thermal noise. We apply the Nyquist's thermal noise theorem to determine thermal noise power in the multi-antenna system and to confirm the partial correlation of thermal noise for antenna spacing lower then one wavelength. Simulation results confirm the decrease of thermal noise power level when antenna spacings drop below a half wavelength.

This paper proposes a new analysis of the transmission coefficient at normal incidence for 2-D periodic crystals (also called Electromagnetic Band Gap (EBG) structures), which are finite in the direction of wave-propagation and are composed of metallic wires. The crystal is considered as a set of parallel Partially Reflecting Surfaces (PRSs), whose transmission and reflection characteristics are obtained rigorously using the Finite Difference Time Domain (FDTD) method. The transmission coefficient of the EBG structure is then obtained by using a plane-wave cascading approach considering single mode interactions between PRSs. The accuracy of the results given by the hybrid method is assessed compared to those obtained directly by the Finite Difference Time Domain (FDTD) method. The minima and maxima envelops and the resonance frequencies of the transmission coefficient are studied, with analytical expressions, for both, excitation from outside and excitation from inside. A discussion is also presented concerning the strength of the coefficient greater than one obtained when the plane-wave source is inside the EBG structure. In addition, by using a transmission line model, a normalized version for this coefficient is proposed, which considers the available power by the source.

A new time-domain theory for waveguides has been presented in the paper. The electromagnetic fields are first expanded by using the complete sets of vector modal functions derived from the transverse electric field. The expansion coefficients are then determined by solving inhomogeneous Klein-Gordon equation in terms of retarded Green's function. The theory has been validated by considering propagation problems excited by various excitation waveforms, which indicates that the higher order modes play a significant role in the field distributions excited by a wideband signal.

The performance of mobile cellular radio networks is limited by the level of cochannel interference that can be tolerated. The use of antennas arrays is very helpful in enhancing the performance and capacity of the wireless communication system. This paper presents a method for antenna pattern synthesis that suppress multiple interfering narrow or wide band signals while receiving the desired signal by controlling only the phase. Excitation phases are computed using the Sequential Quadratic Programming (SQP) technique. This method transforms the nonlinear minimization (or maximization) problem to a sequence of quadratic subproblems, based on a quadratic approximation of the Lagrangian function.

In this article, a theoretical and computational analysis has been made to obtain the modal dispersion characteristics of an unconventional optical waveguide with a Piet Hein core cross section having a conducting sheath helix winding on its core-cladding boundary. A simple analytical method using the vector boundary conditions has been utilized to get the modal eigen value equation. From this equation dispersion curves are obtained and plotted for some particular values of the pitch angles of the winding. Next, these predicted results are compared with those of a new optical fiber having a conducting sheath helix winding on its core-cladding boundary. It is seen that the cutoff values are somewhat lower for the Piet Hein lightguide than those for the circular guide. This is not unexpected since the Piet Hein curve approaches the shape of a square. The introduction of a conducting helical winding leads to a modification of the modal characteristics of the lightguides and gives us an additional means to control them.