2013-11-12
Designing an Octave-Bandwidth Doherty Amplifier Using a Novel Power Combination Method
By
Progress In Electromagnetics Research B, Vol. 56, 327-346, 2013
Abstract
In this paper, an octave bandwidth Doherty power amplifier (DPA) using a novel combiner is presented. The fundamental bandwidth limitation of the load modulation concept of a conventional Doherty structure is solved based on the proposed combination method. For verification, an octave bandwidth asymmetric Doherty architecture is implemented by using gallium-nitride (GaN) HEMT Cree CGH40010 and CGH40025 devices in the carrier and peaking amplifiers, respectively. The carrier and peaking amplifiers are designed to achieve optimal operation with 25 Ω load and source impedances. The reduced load and source impedances simplify the matching circuits for broadband operation. Key building blocks, including the proposed combiner, carrier and peaking amplifiers as well as the 50/25 Ω input power divider, are outlined. The measurement results represent higher than 37% and 52% drain efficiencies in 6 dB load modulation region across the frequency range from 0.85 to 1.85 GHz and 0.90 to 1.60 GHz, respectively. The implemented Doherty amplifier represents acceptable linearity across the whole operation frequency range. In two-tone signal characterization, the implemented DPA performs with a drain efficiency of 55% and an inter-modulation distortion (IMD) of -30 dBc at an average output power of 41.2 dBm at the center operation frequency of 1.35 GHz. In order to observe wideband signal characterization, a single carrier wideband code-division multiple access (W-CDMA) signal with a peak-to-average power ratio (PAPR) of 6.5 dB is applied and a drain efficiency of 51% with an adjacent-channel leakage ratio (ACLR) of -31 dBc is achieved at an average output power of 38.4 dBm.
Citation
Necip Sahan, and Simsek Demir, "Designing an Octave-Bandwidth Doherty Amplifier Using a Novel Power Combination Method," Progress In Electromagnetics Research B, Vol. 56, 327-346, 2013.
doi:10.2528/PIERB13092003
References

1. Steer, M., "Beyond 3G," IEEE Microw. Mag., Vol. 8, No. 1, 76-82, 2007.        Google Scholar

2. Raab, F. H., P. Asbeck, S. Cripps, P. B. Kenington, Z. B. Popovic, N. Pothecary, J. F. Sevic, and N. O. Sokal, "Power amplifiers and transmitters for RF and microwave," IEEE Trans. Microw. Theory Tech., Vol. 50, No. 3, 814-826, 2002.
doi:10.1109/22.989965        Google Scholar

3. Raab, F. H., "Effciency of Doherty RF power-amplifier systems," IEEE Trans. on Broadcasting, Vol. 33, No. 3, 77-83, 1987.
doi:10.1109/TBC.1987.266625        Google Scholar

4. Cripps, S. C., "Doherty and Chireix," Advanced Techniques in RF Power Amplifier Designs, 33-72, 2002.        Google Scholar

5. Kim, B., J. Kim, I. Kim, and J. Cha, "The Doherty power amplifier," IEEE Microw. Mag., Vol. 7, No. 5, 42-50, 2006.
doi:10.1109/MW-M.2006.247914        Google Scholar

6. Lee, Y. S., M. W. Lee, and Y. H. Jeong, "A highly linear and effcient two-stage GaN HEMT asymmetrical Doherty amplifier for WCDMA applications," Microwave and Optical Technology Letters, Vol. 51, No. 6, 1464-1467, 2009.
doi:10.1002/mop.24387        Google Scholar

7. Lee, Y., M. Lee, and Y. Jeong, "Unequal-cells-based GaN HEMT Doherty amplifier with an extended effciency range," IEEE Microw. Wireless Compon. Lett., Vol. 18, No. 8, 536-538, 2008.
doi:10.1109/LMWC.2008.2001015        Google Scholar

8. Kim, J., B. Fehri, S. Boumaiza, and J. Wood, "Power effciency and linearity enhancement using optimized asymmetrical Doherty power amplifiers," IEEE Trans. Microw. Theory Tech., Vol. 59, No. 1, 425-434, 2011.
doi:10.1109/TMTT.2010.2086466        Google Scholar

9. Moon, J., J. Kim, I. Kim, J. Kim, and B. Kim, "A wideband envelope tracking Doherty amplifier for WiMAX systems," IEEE Microw. Wireless Compon. Lett., Vol. 18, No. 1, 49-51, 2008.
doi:10.1109/LMWC.2007.912019        Google Scholar

10. Lee, M. W., S. H. Kam, Y. S. Lee, and Y. H. Jeong, "A highly effcient three-stage Doherty power amplifier with flat gain for WCDMA applications," Journal of Electromagnetic Waves and Applications, Vol. 24, No. 17--18, 2537-2545, 2010.
doi:10.1163/156939310793675619        Google Scholar

11. Feng, Y., Y. Liu, C. Yu, S. Li, J. Li, and X. Zheng , "Design of linearity improved asymmetrical GaN Doherty power amplifier using composite right/left-handed transmission lines," Progress In Electromagnetics Research B, Vol. 53, 89-106, 2013.        Google Scholar

12. Zhou, R. W., Y. Dong, and J. F. Bao, "A 460MHz Doherty amplifier for IMT-advanced system," Progress In Electromagnetics Research Letters, Vol. 32, 187-195, 2012.        Google Scholar

13. Wu, D. Y. and S. Boumaiza, "A modified Doherty configuration for broadband amplification using symmetrical devices," IEEE Trans. Microw. Theory Tech., Vol. 60, No. 10, 3201-3213, 2012.
doi:10.1109/TMTT.2012.2209446        Google Scholar

14. Darraji, R., F. M. Ghannouchi, and M. Helaoui, "Mitigation of bandwidth limitation in wireless Doherty amplifiers with substantial bandwidth enhancement using digital techniques," IEEE Trans. Microw. Theory Tech., Vol. 60, No. 9, 2875-2885, 2012.
doi:10.1109/TMTT.2012.2207910        Google Scholar

15. Kang, D., D. Kim, Y. Cho, B. Park, J. Kim, and B. Kim, "Design of bandwidth-enhanced Doherty power amplifiers for handset applications," IEEE Trans. Microw. Theory Tech., Vol. 59, No. 12, 3474-3483, 2011.
doi:10.1109/TMTT.2011.2171042        Google Scholar

16. Sarkeshi, M., O. B. Leong, and A. Van Roermund, "A novel Doherty amplifier for enhanced load modulation and higher bandwidth," IEEE MTT-S Int. Microw. Symp. Dig., 763-766, 2008.        Google Scholar

17. Qureshi, J. H., N. Li, W. C. E. Neo, F. van Rijs, I. Blednov, and L. C. N. de Vreede, "A wide-band 20W LDMOS Doherty power amplifier," IEEE MTT-S Int. Microw. Symp. Dig., 1504-1507, 2010.        Google Scholar

18. Bathich, K., A. Z. Markos, and G. Boeck, "A wideband GaN Doherty amplifier with 35% fractional bandwidth," Proc. 40th Eur. Microw. Conf., 1006-1009, 2010.        Google Scholar

19. Bathich, K., A. Z. Markos, and G. Boeck, "Frequency response analysis and bandwidth extension of the Doherty amplifier," IEEE Trans. Microw. Theory Tech., Vol. 59, No. 4, 934-944, 2011.
doi:10.1109/TMTT.2010.2098040        Google Scholar

20. Kang, D., D. Kim, J. Moon, and B. Kim, "Broadband HBT Doherty power amplifiers for handset applications," IEEE Trans. Microw. Theory Tech., Vol. 58, No. 12, 4031-4039, 2010.        Google Scholar

21. Sun, G. and R. H. Jansen, "Broadband Doherty power amplifier via real frequency technique," IEEE Trans. Microw. Theory Tech. , Vol. 60, No. 1, 99-111, 2012.
doi:10.1109/TMTT.2011.2175237        Google Scholar

22. Gustafsson, D., C. M. Andersson, and C. Fager, "A modified Doherty power amplifier with extended bandwidth and reconfig- urable effciency," IEEE Trans. Microw. Theory Tech., Vol. 61, No. 1, 533-542, 2013.
doi:10.1109/TMTT.2012.2227783        Google Scholar

23. Pozar, D. M., "Tapered lines," Microwave Engineering, 255-261, 2005.        Google Scholar

24. Lin, S. and A. E. Fathy, "Development of a wideband highly effcient GaN VMCD VHF/UHF power amplifier," Progress In Electromagnetics Research C, Vol. 19, 135-147, 2011.        Google Scholar