volume | PIER Journals

Abstract

Frequency selective surface is a key component in applications such as communication antenna and remote sensing radiometer. One of the core parameters is selectivity, which is usually realized using a multi-layer structure or through a complicated 3D structure. These methods, however, would impose much challenge on alignment or fabrication. This paper proposes a single-substrate and combined-united array to realize a high selectivity frequency selective surface. The unit cell is a combined pattern of cross dipole and square loop to generate double transmission zeroes out of the passband. Both sides of the substrate are printed with the same pattern to enhance the selectivity. Such a structure enables easy fabrication and assembly by avoiding using multi-substrates. A prototype in the Ku-band demonstrates that both sides of the passband show high selectivity.

1. Li, Y., P. Ren, and Z. Xiang, "A dual-passband frequency selective surface for 5G communication," IEEE Antennas and Wireless Propagation Letters , Vol. 18, 2597-2601, 2019.
doi:10.1109/LAWP.2019.2944936 Google Scholar

2. Liu, X., Y. Wang, T. Zhang, et al. "A compact multi-band quasi-optical system for plasma detection," IEEE Transactions on Antennas and Propagation, Vol. 68, 4916-4924, 2020.
doi:10.1109/TAP.2020.2970126 Google Scholar

3. Li, X., X. Liu, K. Ronald, et al. "Investigation of frequency-selective surfaces for a THz gyromultiplier output system," IEEE Transactions on Electron Devices, Vol. 64, 4678-4685, 2017.
doi:10.1109/TED.2017.2746718 Google Scholar

4. Lawrence, H., N. Bormann, A. J. Geer, et al. "Evaluation and assimilation of the microwave sounder MWHS-2 onboard FY-3C in the ECMWF numerical weather prediction system," IEEE Transactions on Geoscience and Remote Sensing, Vol. 56, 3333-3349, 2017.
doi:10.1109/TGRS.2018.2798292 Google Scholar

5. Shen, Y., D. Chen, Q. Wei, et al. "183-GHz frequency selective surface using aligned eight-layer microstructure," IEEE Transactions on Electron Devices, Vol. 39, 1612-1615, 2018. Google Scholar

6. Tao, K., B. Li, Y. Tang, et al. "Multi-layer tri-band frequency selective surface using stepped- and uniform-impedance resonators," Electronics Letters, Vol. 52, 583-585, 2016.
doi:10.1049/el.2016.0324 Google Scholar

7. Yu, Z., X. Yang, J. Zhu, et al. "Dual-band three-dimensional FSS with high selectivity and small band ratio," Electronics Letters, Vol. 55, 798-799, 2019.
doi:10.1049/el.2019.1283 Google Scholar

8. Lv, M., M. Huang, and Z. Wu, "Design of multi-band frequency selective surfaces using multi-periodicity combined elements," Journal of Systems Engineering and Electronics, Vol. 20, 675-680, 2009. Google Scholar

9. Naseri, P., F. Khosravi, P. Mousavi, et al. "Antenna-filter-antenna-based transmit-array for circular polarization application," IEEE Antennas and Wireless Propagation Letters, Vol. 16, 1389-1392, 2017.
doi:10.1109/LAWP.2016.2638469 Google Scholar

10. Li, Y., L. Li, Y. Zhang, et al. "Design and synthesis of multilayer frequency selective surface based on antenna-filter-antenna using Minkowski fractal structures," IEEE Transactions on Antennas and Propagation, Vol. 63, 133-141, 2020.
doi:10.1109/TAP.2014.2367523 Google Scholar

11. Mollaei, M. S. M., "Narrowband configurable polarization rotator using frequency selective surface based on circular substrate-integrated waveguide cavity," IEEE Antennas and Wireless Propagation Letters, Vol. 16, 1923-1926, 2017.
doi:10.1109/LAWP.2017.2688703 Google Scholar

12. Varikuntla, K. K. and R. Singaravelu, "Ultrathin design and implementation of planar and conformal polarisation rotating frequency selective surface based on SIW technology," IET Microwaves, Antennas & Propagation, Vol. 12, 1939-1947, 2018.
doi:10.1049/iet-map.2017.0996 Google Scholar

13. Zhu, J., Z. Hao, C. Wang, et al. "Dual-band 3-D frequency selective surface with multiple transmission zeros," IEEE Antennas and Wireless Propagation Letters, Vol. 18, 596-600, 2019.
doi:10.1109/LAWP.2019.2897369 Google Scholar

14. Lee, I. G. and I. P. Hong, "3D frequency selective surface for stable angle of incidence," Electronics Letters, Vol. 50, 423-424, 2014.
doi:10.1049/el.2014.0053 Google Scholar

15. Afzal, M. U., A. Lalbakhsh, and K. P. Esselle, "Electromagnetic-wave beam-scanning antenna using near-field rotatable graded-dielectric plates," Journal of Applied Physics, Vol. 124, paper ID:234901, 2018.
doi:10.1063/1.5049204 Google Scholar

16. Lalbakhsh, A., M. U. Afzal, and K. P. Esselle, "Multiobjective particle swarm optimization to design a time-delay equalizer metasurface for an electromagnetic band-gap resonator antenna," IEEE Antennas and Wireless Propagation Letters, Vol. 16, 912-915, 2017.
doi:10.1109/LAWP.2016.2614498 Google Scholar

17. Lalbakhsh, A., M. U. Afzal, K. P. Esselle, et al. "Low-cost non-uniform metallic lattice for rectifying aperture near-field of electromagnetic bandgap resonator antennas," IEEE Transactions on Antennas and Propagation, Vol. 68, 3328-3335, 2020.
doi:10.1109/TAP.2020.2969888 Google Scholar

18. Abbaspour-Tamijani, A., K. Sarabandi, and G. M. Rebeiz, "Antenna-filter-antenna arrays as a class of bandpass frequency-selective surfaces," IEEE Transactions on Microwave Theory and Technology, Vol. 52, 1781-1789, 2004.
doi:10.1109/TMTT.2004.831572 Google Scholar

19. Lalbakhsh, P., B. Zaeri, and A. Lalbakhsh, "An improved model of ant colony optimization using a novel pheromone update strategy," IEICE Transactions on Information and Systems, Vol. 96, 2309-2318, 2013.
doi:10.1587/transinf.E96.D.2309 Google Scholar

20. Jamshidi, M. B., A. Lalbakhsh, S. Lotfi, et al. "A neuro-based approach to designing a Wilkinson power divider," International Journal of RF and Microwave Computer-Aided Engineering, Vol. 30, 1-10, 2020.
doi:10.1002/mmce.22091 Google Scholar

21. Jamshidi, M. B., A. Lalbakhsh, B. Mohamadzade, et al. "A novel neural-based approach for design of microstrip filters," AEU --- International Journal of Electronics and Communications, Vol. 110, 152847, 2019.
doi:10.1016/j.aeue.2019.152847 Google Scholar

22. Tang, C., X. Liu, H. Wang, et al. "Design and research of highly selective frequency selective surfaces," Proceeding of the Sixth Asia-Pacific Conference on Antennas and Propagation (APCAP), Xi'an, China, Oct. 16–19, 2017. Google Scholar

23. Lalbakhsh, A., M. U. Afzal, K. P. Esselle, et al. "Single-dielectric wideband partially reflecting surface with variable reflection components for realization of a compact high-gain resonant cavity antenna," IEEE Transactions on Antennas and Propagation, Vol. 67, 1916-1921, 2019.
doi:10.1109/TAP.2019.2891232 Google Scholar

24. Das, P., K. Mandal, and A. Lalbakhsh, "Single-layer polarization-insensitive frequency selective surface for beam reconfigurability of monopole antennas," Journal of Electromagnetic Waves and Applications, Vol. 34, 86-102, 2020.
doi:10.1080/09205071.2019.1688693 Google Scholar

25. Munk, B. A., Frequency Selective Surfaces: Theory and Design, Wiley, 2000.
doi:10.1002/0471723770

26. Liu, X., Z. Li, C. Tang, et al. "Double-square and gridded-square loop frequency-selective surface in the K-band," Microwave and Optical Technology Letters, Vol. 60, 1136-1142, 2018.
doi:10.1002/mop.31126 Google Scholar

27. Liu, X. and J. Yu, "Characterization of the dielectric properties of water and methanol in the D-band using a quasi-optical spectroscopy," Scientific Reports, Vol. 9, paper ID:18962, 2019.
doi:10.1038/s41598-019-55144-4 Google Scholar

28. Lalbakhsh, A., U. A. Muhammad, P. E. Karu, et al. "Multi-objective particle swarm optimization for the realization of a low profile bandpass frequency selective surface," 2015 International Symposium on Antennas and Propagation (ISAP), Hobart, TAS, Australia, Nov. 9–12, 2017. Google Scholar

Dr. Xiaofan Yang

Dr. Liandong Wang

Dr. Xujian Shen

Prof. Xiaoming Liu

Dr. Tao Qi

Dr. Yixin Zhou