volume | PIER Journals

Abstract

The present article shows the design, implementation, and measurement of a compact contactless electronic system for sensing small volumes of liquids. The system is based on two elements: an electronic reader and a passive sensor. The proposed sensor consists of a printed monopole antenna loaded with two Split-Ring Resonators. This results in a fully-passive and single-layer low-cost design. To allow the sensing of small volumes of liquids, a 1-mm-thick adhesive Kapton layer was attached on the top layer of the sensor, and two drop tanks were added to the structure. On the other hand, the reader was designed following a layered approach, which allows us to develop compact and low-cost electronic sensor readers for the Internet of Things. The resulting reader contains a Radio-Frequency interface for the generation of detection of signals, a minicomputer, and the radiating interface. This interface includes a patch antenna that allows us to interrogate the contactless sensor within a 1-cm range. The whole system was manufactured and tested. The total dimensions of the reader are 15 cm × 15 cm, and its weight is below 1 kg. These imply a dramatic form factor and weight reductions with respect to previous readers. Moreover, the manufactured system was used to measure the dielectric permittivity of different liquid drops. Results show that only 4 ml of liquid were needed to determine the dielectric permittivity with a 0.27% error. This volume means a 98.4% reduction compared to submersible sensors which can be found in the literature.

1. Da Fonseca, N. S. S. M., R. C. S. Freire, A. Batista, G. Fontgalland, and S. Tedjini, "A passive capacitive soil moisture and environment temperature UHF RFID based sensor for low cost agricultural applications," 2017 SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference (IMOC), 1-4, Aguas de Lindoia, 2017. Google Scholar

2. Caccami, M. C., M. Y. S. Mulla, and G. Marrocco, "Wireless monitoring of breath by means of a graphene oxide-based radiofrequency identification wearable sensor," 2017 11th European Conference on Antennas and Propagation (EUCAP), 3394-3396, 2017.
doi:10.23919/EuCAP.2017.7928355 Google Scholar

3. Mason, A., O. Korostynska, J. Louis, L. E. Cordova-Lopez, B. Abdullah, J. Greene, R. Connell, and J. Hopkins, "Non-invasive in-situ measurement of blood lactate using microwave sensors," IEEE Transactions on Biomedical Engineering, Vol. 65, No. 3, 698-705, 2017.
doi:10.1109/TBME.2017.2715071 Google Scholar

4. Zhao, A., J. Zhang, and Y. G. Tian, "Miniaturization of UHD RFID tag antenna sensors for corrosion characterization," IEEE Sensors Journal, Vol. 17, No. 23, 7908-7916, 2017.
doi:10.1109/JSEN.2017.2751587 Google Scholar

5. Suwalak, R., C. Phongcharoenpanich, D. Torrungrueng, and M. Krairiksh, "Determination of dielectric property of construction material products using a novel RFID sensor," Progress In Electromagnetics Research, Vol. 130, 601-617, 2012.
doi:10.2528/PIER12070107 Google Scholar

6. Jalo, J., H. P. Sillanpaa, and R. M. Makinen, "Radio interface design for inkjet-printed biosensor applications," Progress In Electromagnetics Research, Vol. 142, 409-422, 2013.
doi:10.2528/PIER13061303 Google Scholar

7. Galindo-Romera, G., F. J. Herraiz-Martınez, M. Gil, J. J. Martınez-Martınez, and D. Segovia-Vargas, "Submersible printed split-ring resonator-based sensor for thin-film detection and permittivity characterization," IEEE Sensors Journal, Vol. 16, No. 10, 3587-3596, 2016.
doi:10.1109/JSEN.2016.2538086 Google Scholar

8. Carnerero-Cano, J., G. Galindo-Romera, J. J. Martınez-Martınez, and F. J. Herraiz-Martınez, "A contactless dielectric constant sensing system based on a split-ring resonator-loaded monopole," IEEE Sensors Journal, Vol. 18, No. 11, 4491-4502, 2018.
doi:10.1109/JSEN.2018.2826982 Google Scholar

9. Sinha, M., V. Killamsetty, and B. Mukherjee, "Near field analysis of rdra loaded with split ring resonators superstrate," Microwave and Optical Technology Letters, Vol. 60, No. 2, 472-478, Wiley, 2018.
doi:10.1002/mop.30995 Google Scholar

10. Mukherjee, B., P. Patel, and J. Mukherjee, "A novel hemispherical dielectric resonator antenna with complementary split-ring-shaped slots and resonator for wideband and low cross-polar applications," IEEE Antennas and Propagation Magazine, Vol. 57, No. 1, 120-128, Feb. 2015.
doi:10.1109/MAP.2015.2397113 Google Scholar

11. Laxman Kumar, A., A. Ranjan, M. Chauhan, V. K. Killamsetty, and B. Mukherjee, "Circular SRR shaped UWB antenna with WiMAX band notch characteristics," 2018 IEEE Radio and Antenna Days of the Indian Ocean (RADIO), 1-2, Grand Port, 2018. Google Scholar

12. Juan, C. G., E. Bronchalo, B. Potelon, C. Quendo, E. Avila-Navarro, and J. M. Sabater-Navarro, "Concentration measurement of microliter-volume water-glucose solutions using Q factor of microwave sensors," IEEE Transactions on Instrumentation and Measurement, Vol. 68, 2621-2634, Jul. 2019. Google Scholar

13. Sharafadinzadeh, N., M. Abdolrazzaghi, and M. Daneshmand, "Highly sensitive microwave split ring resonator sensor using gap extension for glucose sensing," 2017 IEEE MTT-S International Microwave Workshop Series on Advanced Materials and Processes for RF and THz Applications, IMWS-AMP 2017, Vol. 2018, 1-3, Institute of Electrical and Electronics Engineers Inc., Jan. 2018. Google Scholar

14. Tiwari, N. K., S. P. Singh, and M. J. Akhtar, "Quad band metamaterial inspired planar sensor for dispersive material testing," IEEE MTT-S International Microwave and RF Conference, IMaRC 2017, 120-123, Institute of Electrical and Electronics Engineers Inc., Aug. 2018. Google Scholar

15. Altintas, O., M. Aksoy, E. Unal, and M. Karaaslan, "Chemical liquid and transformer oil condition sensor based on metamaterial-inspired labyrinth resonator," Journal of the Electrochemical Society, Vol. 166, No. 6, B482-B488, 2019.
doi:10.1149/2.1101906jes Google Scholar

16. Galindo-Romera, G., J. Carnerero-Cano, J. J. Martınez-Martınez, and F. J. Herraiz-Martınez, "An IoT reader for wireless passive electromagnetic sensors," Sensors, Vol. 17, No. 4, 693, 2017.
doi:10.3390/s17040693 Google Scholar

17. Hazdra, P., M. Mazanek, and J. Cermak, "Wideband rectangular microstrip patch antenna using L-probe feeding system," Radioengineering, Vol. 16, 37-41, 2007. Google Scholar

18. Arduino MKR1000, Available online: https://www.arduino.cc/en/Main/ArduinoMKR1000, accesed on Jun. 06, 2019. Google Scholar

19. Dichtl, C., P. Sippel, and S. Krohns, "Dielectric properties of 3D printed polylatic acid," Advances in Materials Science and Engineering, Vol. 2017, Hindawi, ed., Article ID 6913835, 10 pages, 2017. Google Scholar

20. Felıcio, J. M., C. A. Fernandes, and J. R. Costa, "Complex permittivity and anisotropy measurement of 3D-printed PLA at microwaves and millimeter-waves," 2016 22nd International Conference on Applied Electromagnetics and Communications (ICECOM), 1-6, Dubrovnik, 2016. Google Scholar

Dr. Gabriel Galindo-Romera

Dr. Javier Carnerero-Cano

Dr. José Juan Martínez-Martínez

Dr. Alejandro Rivera-Lavado

Dr. Francisco Javier Herraiz-Martínez