volume | PIER Journals

Abstract

Integrating antennas into a load-bearing airframe structure has the potential for profound improvements in the capability of military and commercial airplanes, by allowing for substantially increased radiator and array size with reduced weight or drag penalties. Reducing the size of array elements can significantly improve the mechanical performance of the loadbearing antenna. The novel single element spiral slot cut in the broad-wall of a WR-90 rectangular waveguide proposed in this paper is smaller than a quarter of the operating wavelength (half of the size of a conventional rectangular slot). The small antenna element enables a slotted waveguide array to be realized without significantly degrading the mechanical performance in load bearing applications. The proposed spiral slot is compared with conventional rectangular slots and exhibits comparable performance in terms of total efficiency (representing coupling from waveguide mode to the slot) and peak realized gain. Total efficiency and peak realized gain of the spiral slot in travelling wave mode are significantly higher than those of a quarter wavelength rectangular slot element which has near zero radiation. The simulated results were validated by manufacturing the spiral slot placed on the broad-wall of a rectangular waveguide. Realized gain patterns of the spiral slot measured at the design frequency corroborate reasonably with the simulations.

1. Rengarajan, S. R., L. G. Josefsson, and R. S. Elliott, "Waveguide-fed slot antennas and arrays: A review," Electromagnetics, Vol. 19, No. 1, 3-22, 1999.
doi:10.1080/02726349908908622 Google Scholar

2. Callus, P. J., Novel Concepts for Conformal Load-bearing Antenna Structure, Tech. Rep. DSTO-TR-2096, DSTO Air Vehicles Div. , Feb. 2008.
doi:http://dspace.dsto.defence.gov.au/dspace/bitstream/1947/9300/1/D

3. Sabat, J. W., "Structural Response of the Slotted Waveguide Antenna Sti®ened Structure Components under Compression," M.S. Thesis, Department of Aeronautics and Astronautics, Air Force Institute of Technology , 2010.
doi:http://www.dtic.mil/cgibin/GetTRDoc?Location=U2&doc=GetTRDoc. Google Scholar

4. Soutis, C., N. A. Fleck, and P. T. Curtis, "Hole-hole interaction in carbon fibre/epoxy laminates under uniaxial compression," Composites, Vol. 22, No. 1, 31-38, 1991.
doi:10.1016/0010-4361(91)90100-U Google Scholar

5. Bethe, H. A., "Theory of diffraction by small holes," Physical Review, Vol. 66, No. 7--8, 163-182, 1944.
doi:10.1103/PhysRev.66.163 Google Scholar

6. Genet, C. and T. W. Ebbesen, "Light in tiny holes," Nature, Vol. 445, No. 7123, 39-46, 2007.
doi:10.1038/nature05350 Google Scholar

7. Ghazi, G. and M. Shahabadi, "Modal analysis of extraordinary transmission through an array of subwavelength slits," Progress In Electromagnetics Research, Vol. 79, 59-74, 2008.
doi:10.2528/PIER07092402 Google Scholar

8. Aydin, K., A. O. Cakmak, L. Sahin, Z. Li, F. Bilotti, L. Vegni, and E. Ozbay, "Split-ring-resonator-coupled enhanced transmission through a single subwavelength aperture ," Physical Review Letters, Vol. 102, No. 1, 013904, 2009.
doi:10.1103/PhysRevLett.102.013904 Google Scholar

9. Cakmak, A. O., K. Aydin, E. Colak, Z. Li, F. Bilotti, L. Vegni, and E. Ozbay, "Enhanced transmission through a subwavelength aperture using metamaterials ," Applied Physics Letters, Vol. 95, No. 5, 052103-3, 2009.
doi:10.1063/1.3195074 Google Scholar

10. Kang, L., V. Sadaune, and D. Lippens, "Numerical analysis of enhanced transmission through a single subwavelength aperture based on mie resonance single particle," Progress In Electromagnetics Research, Vol. 113, 211-226, 2011. Google Scholar

11. Nicholson, K. J., W. S. T. Rowe, P. J. Callus, and K. Ghorbani, "Split-ring resonator loading for the slotted waveguide antenna stiffened structure," IEEE Antennas and Wireless Propagation Letters, Vol. 10, 1524-1527, 2011.
doi:10.1109/LAWP.2011.2181474 Google Scholar

12. Nicholson, K. J., W. S. T. Rowe, P. J. Callus, and K. Ghorbani, "Split-ring resonator loaded slot array," Proc. Asia-Pacific Microwave Conference (APMC), 1338-1341, 2011. Google Scholar

13. Nicholson, K. J., W. S. T. Rowe, P. J. Callus, and K. Ghorbani, "Small slot design for slotted waveguide antenna stiffened structure," Electronics Letters, Vol. 48, No. 12, 676-677, 2012.
doi:10.1049/el.2012.1328 Google Scholar

14. Daliri, A., C. H. Wang, S. John, A. Galehdar, W. S. T. Rowe, K. Ghorbani, and P. J. Callus, "FEA evaluation of the mechanical and electromagnetic performance of slot log-spiral antennas in conformal load-bearing antenna structure (CLAS) ," Proc. ASME Conference on Smart Materials, Adaptive Structures and Intelligent Systems , 613-624, Sep. 2011. Google Scholar

15. Daliri, A., C. H. Wang, A. Galehdar, X. T. Tian, S. John, W. S. T. Rowe, and K. Ghorbani, "A slot spiral in carbon-fibre composite laminate as a conformal load-bearing antenna," Journal of Intelligent Material, Systems and Structures, Jun. 2013. Google Scholar

16. Daliri, A., A. Galehdar, W. S. T. Rowe, K. Ghorbani, S. John, and C. H. Wang, "A spiral shaped slot as a broad-band slotted waveguide antenna," Progress In Electromagnetics Research, Vol. 139, 177-192, 2013. Google Scholar

17. Nicholson, K. J. and P. J. Callus, "Antenna patterns from single slots in carbon fibre reinforced plastic waveguides," Tech. Rep. DSTO-TR-2389, DSTO Air Vehicles Div., Feb. 2010.
doi:http://www.dtic.mil/cgibin/GetTRDoc?Location=U2&doc=GetTRDoc.pdf Google Scholar

Dr. Ali Daliri

Dr. Amir Galehdar

Prof. Wayne Rowe

Prof. Kamran Ghorbani

Dr. Chun H. Wang

Dr. Sabu John